How To Repair Plastic Lamp Base

If you have a lamp with a loose socket that causes the lamp to flicker, to be difficult to turn on, or to merely flat out refuse to light, you lot can replace the socket and give the lamp a new life. You can replace a socket and so hands that, even if it's not your favorite lamp, you may want to fix it and give it to someone else, like your nosy neighbour.

You tin can purchase replacement lamp parts at any hardware store or home heart. These parts are standard; you can buy lamp cord by the foot, and yous tin use only about whatever type of plug to replace the one on your quondam lamp.

You tin can find several varieties of lamp socket switches. You control some past pushing a short shaft on the side of the switch, others by turning a knob, and withal others with a pull chain. You also need to consider whether your present lamp has a three-style bulb in it. If you could turn the lamp on to several degrees of brightness, be certain to purchase a socket switch that'south designed to command a three-way bulb.

You lot can probably get the right replacement parts almost easily by taking the lamp apart (according to the following directions) and bringing the bad parts to the store so that you tin can find matching replacements.

To replace a lamp socket, follow these steps:

1. Unplug the lamp.

2. Remove the shade, bulb, and harp (the wired shape that holds the shade).

3. Snap off the socket vanquish from the socket shell cap.

   

   Well-nigh sockets take the word Press stamped in two places on the crush. Squeeze the shell at those points and pull upwards to remove it. If the beat doesn't budge, button the finish of a screwdriver between the base of the socket and the side of the shell so pull the crush up and off the socket base.

4. Pull the socket switch upward out of the beat out base to expose enough of the switch to reveal the 2 wires attached to information technology.

   If the screws are loose, tighten them and reassemble the lamp. Loose screws may have been the lamp'southward only problem. If the lamp works after y'all tighten upwards the screws, great! If not, take it apart again and proceed with the post-obit steps.

5. Unscrew the wires.

   A lamp switch has a brass screw to which the hot (black) wire is attached and a silvery screw to which the neutral (white) wire is attached. Lamp cords, however, don't have colored wires in them. Then, before you remove the wires from the one-time switch, note which color screw each wire is connected to.

6. Loosen the socket cap gear up spiral and so unscrew and discard information technology forth with the quondam socket shell and socket.

7. Screw the wire leads to the new socket.

8. Identify the new socket shell over the socket and push the cover down until it snaps into the new socket crush cap.

9. Supplant the harp, low-cal bulb, and shade.

Near This Article

This article can be found in the category:

• Electrical ,

How To Repair Plastic Lamp Base,

Source: https://www.dummies.com/article/home-auto-hobbies/home-improvement-appliances/electrical/how-to-repair-a-faulty-lamp-185375/

Posted by: hernandezbourponshave.blogspot.com

Share this post